TM 9-2320-361-34 15-30. SIDE WINDOW SASH MAINTENANCE THIS TASK COVERS: a. Removal c. Installation b. Inspection and Repair INITIAL SETUP APPLICABLE MODELS M185A3 and M109A3 TOOLS REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-34P General mechanic’s tool kit (Appendix B, Item 1) EQUIPMENT CONDITlON Riveting tool (Appendix B, Item 20) Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS Eighteen screw-assembled lockwashers (Appendix F, Item 162) Tool screw-assembled lockwashers (Appendix F, Item 163) Rivet (Appendix F, Item 211) Six screw-assembled lockwashers (Appendix F, Item 164) 1. Remove lever ring (9), eighteen screw-assembled lockwashers (10), and screen (8) from sash frames (1) and (4). Discard screw-assembled lockwashers (10). NOTE Pull down blackout panel from outside van body. 2. Remove ten screw-assembled lockwashers (14), two guides (15), and blackout panel (16) from van body wall (6). Discard screw-assembled Iockwashers (14). 3. Remove six screw-assembled lockwashers (12) and hinge (13) horn van body wall (6). Discard screw- assembled lockwashers (12). 4. Remove twenty-two screws (11), sash frames (1) and (4), weatherstrip (2), and window glass (3) from van body wall (6). 5. Drill rivet (5) out of arm (7) and remove arm (7) from sash frame (4). Discard rivet (5). b. Inspection and Repair Inspect screen (8), blackout panel (16), two guides (15), and window glass (3) for holes, bends, dents, or cracks. Repair screen (8) by patching. Replace cracked window glass (3). Replace blackout panel (16) or guide(s) (15) if bent, dented, or cracked. c. Installation 1. Install arm (7) on sash frame (4) with new rivet (5). 2. Install weatherstrip (2) on window glass (3). 3. Install window glass (3) and sash frame (4) on sash frame (1) with twenty-two screws (11). 4. Install hinge (13) on van body wall (6) with six new screw-assembled lockwashers (12). 5. Install two guides (15) and blackout panel (16) on van body wall (6) with ten new screw- assembled lockwashers (14). 6. Install screen (8) on sash frames (1) and (4) with eighteen new screw-assembled lockwashers (10). 7. Install lever ring (9) on arm (7). 15-112