TM 9-2320-361-34 15-24. 115- AND 24-VOLT WIRING HARNESS REPLACEMENT (Contd) b. Installation CAUTION Use care when installing wiring harnesses. Excessive snagging or pulling may damage wires. NOTE Safety wire must be secured to wiring harnesses with electrical tape. 1. 2. 3. 4. 5. Position main wiring harness (2) in roof (3). Secure main wiring harness (2) by closing tabs (1). Install three grommets (9) and two grommets (13) in van wall (4). Attach safety wires (7) to five wire leads (5), (6), (8), (11), and (12). NOTE Do not remove safety wire from wire leads Pull safety wires (7) so that wire leads (5), (6), (8), (11), until wires are connected. and (12) are pulled through van wall (4). 15-90