TM 9-2320-361-34 15-24. 115- AND 24-VOLT WIRING HARNESS REPLACEMENT (Contd) 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. NOTE Perform steps 6 and 7 on each side of van. Remove cap (1), clip (2), and cover (3) from receptacle strip (4). Pull receptacle wires (6) forward, remove electrical tape from connectors (7) and cut receptacle wires (6) from main wiring harness (5). NOTE Safety wire will be used to install new wiring harness. Do not cut safety wire from spool until harness has been pulled from van and proper length has been obtained. Attach safety wire (15) to 115-volt domelight wires (13). Pull 115-volt domelight wires (13) out of van body (8). Remove safety wire (15) from 115-volt domelight wires (13). Cut safety wire (15) from spool (14). Attach safety wire (15) to 24-volt domelight wires (12). Pull 24-volt domelight wires (12) out of van body (8). Remove safety wire (15) from 24-volt domelight wires (12). Cut safety wire (15) from spool (14). Attach safety wire (15) to 115-volt domelight wires (11). Pull 115-volt domelight wires (11) out of van body (8). Remove safety wire (15) from 115-volt domelight wires (11). Cut safety wire (15) from spool (14). Attach safety wire (15) to 24-volt domelight wires (10). NOTE Both 115-volt receptacle connections are removed the same. This procedure covers one connection. Attach safety wire (15) to 115-volt receptacle connections (16). Pull 24-volt domelight wires (10) and 115-volt receptacle connections (16) out of van body (8). Remove safety wire (15) from wires (10) and 115-volt receptacle connections (16). Cut safety wire (15) from spool (14). Attach safety wire (15) to 115-volt domelight wires (9). Pull 115-volt domelight wires (9) out of van body (8). Remove safety wire (15) from wires (9). Cut safety wire (15) from spool (14). 15-82