TM 9-2320-361-34 15-6. CAB PROTECTOR MAINTENANCE THIS TASK COVERS: a. Removal c. Installation b. Cleaning and Inspection INITIAL SETUP APPLICABLE MODELS M342A2 TOOLS General mechanic’s tool kit (Appendix B, Item 1) Lifting device Two screws (Appendix F, Item 213) Two locknuts (Appendix F, Item 106) Four washers (Appendix F, Item 268) MATERIALS/PARTS Fifteen locknuts (Appendix F, Item 105) Four cotter pins (Appendix F, Item 7) PERSONNEL REQUIRED REFERENCES (TM) FM 43-2 TB 43-0209 TM 9-237 TM 9-2320-361-10 TM 9-2320-361-34P TM 43-0139 EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). GENERAL SAFETY INSTRUCTIONS All personnel must stand clear during lifting operations. Two a. Removal Remove three screws (6) and locknuts (7) from cab protector (10) and dump body (20). Discard locknuts (7). 2. 3. 4. 5. 6. 7. WARNING 8, 9. 10. 11. 12. 13. Remove four screws (19) and locknuts (18) from upper and lower cab protector brackets (13). Discard locknuts (18). NOTE Assistant will help with step 3. Tilt upper cab protector (17) over top of lower cab protector (10) and install on lower cab protector (10) with four screws (4) and nuts (5). Install chain on lower cab protector brackets (13) with two screws (11), washers (12), washers (14), and locknuts (15). Install guide line on cab protector (17). Install lifting device on chain and remove slack from chain. Remove eight screws (9) and locknuts (8) from lower cab protector (10) and dump body (20). Discard locknuts (8). All personnel must stand clear during lifting operations. A shifting or swinging load may cause injury to personnel. Remove upper and lower cab protectors (17) and (10) from dump body (20) and place on wooden supports. Remove four nuts (5) and screws (4) horn upper and lower cab protectors (17) and (10). Remove four cotter pins (3), washers (2), and two pins (1) from two hinges (16). Discard cotter pins (3). Lift upper cab protector (17) away from lower cab protector (10) and place on wooden supports. Remove lifting device from chain. Remove two nuts (15), screws (11), two washers (14), washers (12) and chain from lower cab protector brackets (13). Remove guide line from cab protector (17). 15-20