TM 9-2320-361-34 CHAPTER 15 SPECIAL PURPOSE BODIES MAINTENANCE Section I. Cargo Bodies Maintenance (page 15-1) Section II. Dump Body Maintenance (page 15-8) Section III. Fuel Tank and Water Tank Bodies Maintenance (page 15-24) Section IV. Van and Repair Shop Bodies Maintenance (page 15-63) Section V. Earth Boring and Polesetting Bodies Maintenance (page 15-122) Section VI. Pipeline Construction Body Maintenance (page 15-215) Section 1. CARGO BODIES MAINTENANCE I 15-1. CARGO BODIES MAINTENANCE THIS TASK COVERS: a. Removal c. Repair b. Cleaning and Inspection d. Installation INITIAL SETUP APPLICABLE MODELS M35A2, M35A2C, and M36A2 TOOLS General mechanic’s tool kit (Appendix B, Item (1) 1-1/8-in. socket, 3/4-in. dr. (Appendix B, Item 33) 1-1/16-in. socket. 3/4-in. dr. (Appendix B, Item 61) Torque wrench, 3/4-in. dr. (Appendix B, Item 6) Breaker bar, 3/4-in. dr. (Appendix B, Item 34) Handle, socket wrench, 3/4-in. dr. (Appendix B, Item 35) Lifting device MATERIALS/PARTS Four locknuts (Appendix F, Item 95) Four locknuts (Appendix F, Item 103) Four locknuts (Appendix F, Item 105) Six locknuts (Appendix F, Item 104) PERSONNEL REQUIRED Two REFERENCES (TM) TB 43-0209 TC 9-510 TM 9-2320-361-20 TM 9-2320-361-34P TM 9-237 TM 43-0139 EQUIPMENT CONDITION ● Cargo body side racks and troop seat removed (M35A2C, M36A2) (TM 9-2320-361-20). ● Cargo body front rack removed (M35A2C, M36A2) (TM 9-2320-361-20). . Cargo body front splash guards removed (M35A2C, M36A2) (TM 9-2320-361-20). ● Cargo body upper and lower rear splash guards removed (M35A2C) (TM 9-2320-361-20). ● Reflectors removed (TM 9-2320-361-20). GENERAL SAFETY INSTRUCTIONS ● All personnel must stand clear during lifting operations. ● Ensure lifting capacity is greater than weight of cargo body. 15-1