TM 9-2320-361-34 14-4. WINDSHIELD GLASS REPLACEMENT THIS TASK COVERS: a. Removal b. Installation INITIAL SETUP APPLICABLE MODELS All REFERENCES (TM) TM 9-2320-361-20 TOOLS TM 9-2320-361-34P General mechanic’s tool kit (Appendix B, Item 1) EQUIPMENT CONDITION . Windshield assembly removed (TM 9-2320-361-20). MATERIALS/PARTS ● Windshield arm, glass, and handle removed Two lockwashers (Appendix F, Item 139) (TM 9-2320-361-20). Filler strip (Appendix F, Item 264) Filler strip (Appendix F, Item 265) Adhesive (Appendix C, Item 1) a. Removal 1. Remove six screws (1), two nuts (4), four washers (9), and two lockwashers (3) from windshield frame (8). Discard lockwashers (3). 2. Remove crosspiece (2) from windshield frame (8). NOTE Measure old frame filler strips for installation. 3. Remove crosspiece filler strip (5) from crosspiece (2). Discard crosspiece filler strip (5). 4. Remove glass (6) and frame filler strips (7) from windshield frame (8). Discard frame filler strips (7). b. Installation NOTE Cut four new filler strips to size. 1. Apply adhesive to new frame filler strips (7). Install new frame filler strips (7) on glass (6). 2. Install glass (6) in windshield frame (8). Tap glass (6) gently into position. 3. Apply adhesive to new crosspiece filler strip (5). Install new crosspiece filler strip (5) on glass (6). 4. Install crosspiece (2) on windshield frame (8) and gently tap until screw holes aline. 5. Install crosspiece (2) on windshield frame (8) with six screws (1), four washers (9), two new lockwashers (3), and nuts (4). Trim excess filler strips (7) and (5) and adhesive from around glass (6). 14-2