TM9-2320-361-34 ● ● ● ● ● ● ● ● ● ● ● ● ● e ● ● ● ● ● ● ● e ● ● b WARNING SUMMARY (Contd) Stay clear of drive gear area during inspection of input shaft seal when engine is operating. Failure to stay clear of drive gear area may result in injury to personnel. Fuel is flammable. Do not perform troubleshooting checks near open flame, sparks, or electricity. Injury to personnel may result. Eye protection is required when performing fuel system troubleshooting checks. Failure to wear eye protection may result in injury to personnel. Ignition switch must remain off during fuel system troubleshooting checks. Failure to verifi that ignition system is turned off may result in injury to personnel. When rod clevis position is not tight against cover window bearing screw, fuel shutoff rod maybe binding. Verify fuel shutoff rod travels freely before adjusting clearance between rod clevis and bearing screw. Failure to verify fuel shutoff rod condition may result in governor sticking under acceleration and injury to personnel. Hot coolant is under pressure. Care should be used when removing radiator filler cap or inspecting hot engine coolant leaks. Steam or hot coolant under pressure may cause severe injury to personnel. Overhead lifting device capacity must exceed dump body weight. A shifting or falling load may cause injury to personnel. Bleed hydraulic pressure before cracking hydraulic lines. Failure to do so may result in injury to personnel or damage to equipment. Use properly rated hydraulic hose when performing hydraulic system checks on vehicles not equipped with dump body lock. Failure to do so may result in injury to personnel. Overhead lifting device must remain attached to dump body until troubleshooting is completed. All personnel must stand clear of dump body during lowering test. Falling dump body may cause injury to personnel. Eye protection is required when inspecting internal clutch case operation on vehicle. Failure to do so may result in fluid contacting eyes and injury to personnel. Eye protection is required when performing hydraulic systems checks. Failure to do so may result in injury to personnel. Improper cleaning methods and use of unauthorized cleaning solvents may cause injury to personnel or damage to equipment. Hand protection must be worn during nut retightening. Engine surface is hot and can cause injury to personnel. Flywheel is heavy. Use care when removing flywheel. Failure to do so may result in injury to personnel or damage to equipment. Disconnect battery ground cable prior to performing valve adjustment procedure. Failure to do so may cause injury to personnel. Axle is heavy. Ensure axle is balanced and body parts are clear before lowering axle. Failure to do so may result in injury to personnel. Tandem axle is heavy. Support tandem axle during removal. Failure to do so may result in injury to personnel. Do not perform fuel system or heater testing procedures while smoking or within 50 feet of sparks or open flame. Fuel is flammable and can explode, causing injury or death to personnel and damage to equipment. Support main drive idler gear housing before removing hardware. Failure to do so may result in injury to personnel or damage to equipment. Ensure lifting capacity of hoist is greater than the weight of the component being raised. Failure to do so may result in injury to personnel. Toolbox is heavy. Support toolbox during removal and installation. Failure to do so may result in injury to personnel. Power divider is heavy. Support power divider during removal and installation. Failure to do so may result in injury to personnel.