TM 9-2320-361-34 12-3. STEERING GEAR REPAIR (Contd) 2. 3. 4. 5. 6. 7. 8. 9. Clamp gear housing mounting seal (11) in vise with cam (5) bore positioned up. Install cup (7) over end cover tube (8) and seat in gear housing (3). Lubricate cam bearings (29) and (6) with oil prior to cam (5) installation. Install cam bearings (29) and (6) and cup (28) on cam (5). Install cam (5) over end cover tube (8) through gear housing (3) and seat bearing (6) on cup (7). Install plugs (10), (12), and (16) in gear housing (3) and side cover (21). Position new gasket (26), shim(s) (27), new gasket (26), gear tube cover (25), and gear tube (22) over cam (5) on gear housing (3) and install with four washers (23) and new screws (24). Tighten screws (24) 35 lb-ft (47.5 N.m). Ensure rotational drag on cam end (30) is 3-8 lb-in. (0.3-0.9 N.m). NOTE If rotational drag on shaft is not within specifications, add or remove smallest shim for each adjustment until specifications are met. 10. Lubricate pitman shaft bearings (14) with gear oil prior to pitman shaft (13) installation. 11. Install pitman shaft (13) in gear housing (3). 12. Install new gasket (15) and side cover (21) on gear housing (3) with six washers (20) and screws (19). 13. Install preload screw (17) with nut (18) in side cover (21). Do not tighten screw (17) or nut (18). FOLLOW-ON TASK :Install steering gear (para. 12-2). 12-11 (12-12 blank)