TM 9-2320-361-34 I 11-3. PARKING AND SERVICE BRAKESHOE REPAIR THIS TASK COVERS: a. Disassembly c. Assembly b. Cleaning and Inspection INITIAL SETUP APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-20 TOOLS TM 9-2320-361-34P General mechanic’s tool kit (Appendix B, Item 1) EQUIPMENT CONDITION Parking or service brakeshoes removed Brake reliner (Appendix B, Item 12) (TM 9-2320-361-20). MATERIALS/PARTS GENERAL SAFETY INSTRUCTIONS Service brakeshoe parts kit ● Do not use compressed air or dry brush for (Appendix F, Item 190) cleaning in areas where asbestos brake lining dust Parking brakeshoe parts kit may accumulate. (Appendix F, Item 189) ● Keep fire extinguisher nearby when using Drycleaning solvent (Appendix C, Item 24) drycleaning solvent. NOTE ● Parking and service brakeshoes are repaired basically the same. This task covers service brakeshoe repair. ● All service and parking brakeshoe linings must be replaced as matched sets. Remove fourteen rivets (4) and lining (2) from service brakeshoe (1). Discard rivets (4). I b. Cleaning and Inspection I WARNING ● Do not use compressed air or dry brush for cleaning when working in areas of vehicle where asbestos brake lining dust may accumulate. Remove asbestos dust and other residue from these areas using a soft bristle brush or cloth soaked with water. Breathing asbestos dust may cause injury to personnel. ● Drycleaning solvent is flammable and will not be used near open flame. Use only in well-ventilated places. Failure to do so may result in injury or death to personnel. 1. Clean brakeshoe (1) with water and soft bristle brush. Allow to air dry. Clean with drycleaning 2. Check brakeshoe (1) for cracks, warps, flat spots on faces, and out-of-round rivet holes (3). Replace if cracked, warped, flat, or holes are out-of-round. solvent. c. Assembly Install lining (2) on service brakeshoe (1) with fourteen new rivets (4). 11-4