TM 9-2320-361-34 10-6. STEERING KNUCKLE AND STEERING ARM MAINTENANCE (Contd) 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Remove spacer (8) from left and right steering knuckles (3). NOTE ● If dial indicator reading was less than 0.004 in. (O.102 mm), install smaller spacer. . If dial indicator reading was more than 0.014 in. (0.356 mm), install larger spacer. Install spacer (8) on left and right steering knuckles (3). NOTE ● Step 10 applies to right steering knuckle. ● Steps 11 and 12 apply to left steering knuckle. Install plate (1), two-new lockwashers (12), screws (10), and lubrication fitting (11) on steering knuckle (3). Tighten screws (10) 116-149 lb-ft, (157-202 N.m). Install steering arm (7) on four studs (9) with four new lockwashers (5) and nuts (4). Tighten nuts (4) 130-167 lb-ft (176-226 N.m). Install lubrication fitting (6) on steering arm (7). Check endplay (steps 1 through 3). Install drag link (TM 9-2320-361-20). Install tie rod (TM 9-2320-361-20). Install steering knuckle boot (TM 9-2320-361-20). Install front axle shaft (TM 9-2320-361-20). LEFT SIDE RIGHT SIDE 10-41