TM 9-2320-361-34 I 10-4. DIFFERENTIAL CARRIER REPAIR (Contd) 16. Using bearing sleeve remover/replacer and screw, aline hole in sleeve (1) with setscrew (7) hole in carrier (2) and install sleeve (1) in carrier (2). 17. Install setscrew (7) in carrier (2) and sleeve (1). NOTE Install bearing with beveled side toward gear. 18. Press bearing (4) on bevel gear (3). 19. Install spacer (8) on bevel gear (3) until seated against bearing (4). 20. CAUTION Use brass drift to install bevel gear. Failure to do so may result in damage to gear. Install bevel gear (3) in carrier (2) so bevel gear (3) rests in sleeve (1). 21. Install key (6) on helical pinion shaft (5). CAUTION 22. Use soft metal spacers to securely support bevel gear on sleeve during installation. The bevel gear must not be able to move within the housing. Failure to do so may result in damage to bevel gear and/or housing. NOTE Ensure alinement of key in helical pinion shaft with keyway in bevel gear. Press pinion shaft (5) through carrier (2) into bevel gear (3). 10-20