TM 9-2320-361-34 10-4. DIFFERENTIAL CARRIER REPAIR (Contd) 26. Remove six screws (5), lockwashers (4), bearing cover (3), and shims (2) from carrier (1). Discard lockwashers (4). Record number/thickness of shims (2) removed. Tie shims (2) to bearing cover (3). NOTE Use brass drift to hold bevel gear in place while removing screws. 27. Remove safety wire (8), two screws (7), and plate (6) from helical pinion shaft (11). Discard safety wire (8). Puller screws must be turned evenly until bearing cage is free from earner. Failure to remove cage evenly will result in damage to bearing cage, bearings, and carrier. 28. Remove bearing cage (9) and shims (10) from carrier (1) with two puller screws. Record number/thickness of shims (10) removed. Tie shims (10) to bearing cage (9). CAUTION Use brass drift to remove bearings and bearing seat from bearing cage. Failure to do so may result in damage to bearings and bearing seat. 29. Remove bearing seat (12), bearings (13) and (14), and bearing seat (15) from bearing cage (9). ● Support beveled gear with soft spacers. Failure to do so may result in damage to equipment. ● When removing pinion shaft ensure shaft does not become caught on carrier housing. Failure to do so may result in damage to pinion shaft. 30. Press helical pinion shaft (11) from bevel gear (16). 31. Remove woodruff key (21) from helical pinion shaft (11). Discard woodruff key (21). CAUTION Use brass drift to remove bevel gear, bearing, and spacer from carrier. Failure to do so may result in damage to gear, bearings, or spacer. 32. Remove bevel gear (16), bearing (20), and spacer (19) from carrier (1). 33. Remove spacer (19) from bearing (20). 34. Remove bearing (20) from bevel gear (16). 35. Remove setscrew (17) from carrier (1). 36. Using bearing sleeve remover/replacer, remove sleeve (18) from carrier (1). 10-10