TM 9-2320-361-34 10-4. DIFFERENTIAL CARRIER REPAIR (Contd) 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 10-8 Remove eight screws (2), lockwashers (1), top cover (3), and gasket (4) from earner (5). Discard lockwashers (1) and gasket (4). Remove four screws (9), washers (8), inspection cover (7), and gasket (6) from carrier (5). Discard gasket (6). NOTE Ensure flanges are secured in vise for easy removal of nuts and washers. Remove two cotter pins (10), nuts (11), and washers (12) from shaft (24). Discard cotter pins (10). Using mechanical puller, remove two flanges (13) with dirt deflectors (14) from shaft (24). NOTE Perform step 18 if dirt deflectors are damaged or flanges require replacement. Remove two dirt deflectors (14) from flanges (13). Remove twelve screws (15), washers (16), front retainer (17), rear retainer (19), and shims (18) from carrier (5). Record number/thickness of shims (18) removed from front retainer (17) and rear retainer (19). Tie shims (18) to front retainer (17) and rear retainer (19). Remove spacer (27) from shaft (24). Using oil seal remover, remove two oil seals (20) from retainers (17) and (19). Discard oil seals (20). CAUTION Use brass drift to remove shaft and bearing seat. Failure to do so may result in damage to shaft and bearing seat. Remove shaft (24) and bearing seat (21) through rear of carrier (5). Remove bearing seat (26) from front of carrier (5). Remove front bearing (25) and pinion (23) with rear bearing (22) from shaft (24). Remove rear bearing (22) from hub of pinion (23).