TM 9-2320-361-34 I 10-3. DIFFERENTIAL CARRIER REPLACEMENT (Contd) I I b. Installation I 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Install chains on carrier (7) with washer (4) and screw (5). Install new gasket (11) on housing (6). Install lifting device on chain. WARNING All personnel must stand clear during lifting operations. A swinging or shifting load may cause injury to personnel. CAUTION When lowering differential carrier onto axle housing, use care not to damage mounting studs. NOTE Assistant will help with steps 4 and 5. Using lifting device, install carrier (7) on housing (6) leaving 1/2 in. (1.3 cm) gap between carrier (7) and housing (6). Install four washers (9) and nuts (10) on studs (8) and lower carrier (7) onto housing (6). Install eight remaining washers (2) and nuts (1) on eight studs (3). Alternately tighten nuts (10) and (1). Remove lifting device from chain. Remove screw (5), washer (4), and chain from carrier (7). Install washer (4) and screw (5) on carrier (7). Tighten screw (5) 65-85 lb-ft (88-115 N.m). Install drain plug (12) on bottom of housing (6). Tighten drain plug (12)35 lb-ft (48 N.m). FOLLOW-ON TASKS: . ● ● Install axle assembly (para. 10-2 or 10-8). Install axle shafts (TM 9-2320-361-20). Fill axle housing with GO 80/90 oil (LO 9-2320-209-12-1). 10-5