TM 9-2320-361-34 CHAPTER 8 TRANSMISSION MAINTENANCE 8-1. TRANSMISSION MAINTENANCE INDEX PARA. TITLE PAGE NO. NO. 8-2. Transmission Maintenance 8-1 8-3. Clutch Release Bearing, Shaft, and Fork Replacement 8-6 8-4. Transmission Top Cover Replacement 8-8 8-2. TRANSMISSION MAINTENANCE THIS TASK COVERS: a. Removal c. Installation b. Inspection and Repair INITIAL SETUP APPLICABLE MODELS EQUIPMENT CONDITION All TOOLS General mechanic’s tool kit (Appendix B, Item 1) Sling (Appendix B, Item 14) Breaker bar, l/2-in. dr. (Appendix B, Item 15) Torque wrench, 1/2-in. dr. (Appendix B, Item 7) Lifting device Two chains Four screws (Appendix F, Item 217) Four washers (Appendix F, Item 271) MATERIALS/PARTS Twelve screw-assembled lockwashers (Appendix F, Item 156) Four screw-assembled lockwashers (Appendix F, Item 157) Two locknuts (Appendix F, Item 96) Gasket (Appendix F, Item 80) Lockwasher (Appendix F, Item 128) PERSONNEL REQUIRED ● Battery negative ground cable disconnected (TM 9-2320-361-20). ● Cab top removed (if overhead lifting device is used) (TM 9-2320-361-10). . Transmission gearshift lever removed (TM 9-2320-361-20). ● Cab tunnels removed (TM 9-2320-361-20). ● Power takeoff propeller shaft removed (vehicles w/PTO installed) (TM 9-2320-361-20). ● Transfer case to transmission propeller shaft removed (TM 9-2320-361-20). . Transfer case to differential propeller shaft removed (TM 9-2320-361-20). . Transmission oil drained (LO 9-2320-209-12-1). GENERAL SAFETY INSTRUCTIONS ● Use prybar to free transmission during lifting operations. ● All personnel must stand clear during lifting operations. Two REFERENCES (TM) LO 9-2320-209-12-1 TM 9-2320-361-10 TM 9-2320-361-20 TM 9-2320-361-34P TM 9-2520-246-34-1 8-1