TM 9-2320-361-34 7-3. FRONT WIRING HARNESS REPLACEMENT THIS TASK COVERS: a. Removal b. Installation INITIAL SETUP APPLICABLE MODELS All TEST EQUIPMENT Multimeter (Appendix B, Item 3) TOOLS General mechanic’s tool kit (Appendix B, Item 1) Tool kit, electrical (Appendix B, Item 2) Torque wrench, 3/8-in. dr. (Appendix B, Item 8) MATERIALS/PARTS Six lockwashers (Appendix F, Item 132) Lockwasher (Appendix F, Item 124) Six locknuts (Appendix F, Item 95) Three locknuts (Appendix F, Item 89) Two tiedown straps (Appendix C, Item 15) Adhesive sealant (Appendix C, Item 2) REFERENCES (TM) TM 9-2320-361-20 TM 9-2320-361-34P EQUIPMENT CONDITION Accessorv switch removed (TM 9-2320-361-20). “ NOTE Tag wires for installation. 1. Disconnect wire (9) from horn wire (8). 2. Disconnect wires (3) and (5) from left headlamp (1). 3. Disconnect wire (11) from blackout drive lamp (12). 4. Remove nut (7) and clamp (6) from front wiring harness (10) and stud (13). 5. Remove tiedown strap (4) from front wiring harness (10) and brush guard support (2). Discard tiedown strap (4). 7-19