TM 9-2320-361-34 CHAPTER 2 SERVICE AND TROUBLESHOOTING INSTRUCTIONS Section I. Repair Parts, Special Tools, Test, Measurement, and Diagnostic Equipment (TMDE), and Support Equipment (page 2-1) Section II. Troubleshooting (page 2-1) Section III. General Maintenance Instructions (page 2-32) Section 1. REPAIR PARTS, SPECIAL TOOLS, TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT I 2-1. COMMON TOOLS AND EQUIPMENT Refer to Modified Table of Organization and Equipment (MTOE) for authorized common tools and equipment applicable to your unit. I 2-2. SPECIAL TOOLS AND SUPPORT EQUIPMENT I Special tools and support equipment are listed and illustrated in TM 9-2320-361-34P. I 2-3. TEST MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE) Calibrate all measuring and test equipment used to determine equipment conformance in accordance with MIL-STD-120, MIL-C-45662, and MIL-L-45607. 2-4. FABRICATED TOOLS Fabricated tools needed to maintain the equipment mentioned in this manual can be found in Appendix D. These tools are not available for issue; therefore, each one must be fabricated and applied by direct or general support personnel. 2-5. REPAIR PARTS Repair parts are listed and illustrated in TM 9-2320-361-34P. Section Il. TROUBLESHOOTING I 2-6. GENERAL TROUBLESHOOTING INSTRUCTIONS 2-1