TM 9-2320-361-34 7-2. 60 AMPERE ALTERNATOR REPAIR (Contd) 15. Remove tiedown strap (1) from three leads (2). Discard tiedown strap (1). 16. Disconnect lead (20) from output plate stud (6). 17. Remove insulating compound from four rectifier terminals (10) and three rectifier terminals (16). CAUTION Use heat sink when resoldering leads. Failure to do so may result in damage 18. Desolder and disconnect six positive rectifier leads (11) from four positive rectifier terminals (10). 19. Remove three screws (12), washers (13), nylon washers (14), positive rectifier plate (9), and positive rectifier insulator (8) from end housing (3). CAUTION Use heat sink when desoldering leads. Failure to do so may result in damage to equipment. 20. Desolder and disconnect three negative rectifier leads (15) from three negative rectifier terminals (16). 21. Remove two screws (17), washers (18), and negative rectifier plate (19) from end housing (3). 22. Remove four screws (4), output plate (5), O-ring (7), six positive rectifier leads (11), three negative rectifier leads (15), and leads (2) from end housing (3). Discard O-ring (7). 23. Scribe locating marks (24) on intermediate housing (23), stator (22), and drive end housing (21). 7-6