TM-9-2320-361-24-2 Field Maintenance Manual Volume 2 for M44A2 Series Trucks
Page 620 of 1144
TM 9-2320-361-24-2 0365 00 0365 00-2 SLAVE RECEPTACLE REPLACEMENT (Contd) REMOVAL 1. Remove locknut (19), two lockwashers (18), ground cable (5), and screw (17) from rear battery support hanger (16). Discard locknut (19) and lockwashers (18). 2. Remove nut (33), screw (31), and positive cables (22) and (34) from positive battery terminal (32). 3. Remove screw (27) washer (26), lockwasher (25), two clamps (24), ground cable (5), and positive cable (22) from cab back panel support (23). Discard lockwasher (25). 4. Remove two grommets (24), positive cable (22), and ground cable (5) from cab floor (29). 5. Remove four locknuts (20) and screws (21) from cab (9) and reinforcement plate (10). Discard locknuts (20). 6. Remove four locknuts (14), lockwashers (15), screws (1), lockwashers (2), slave receptacle cap (30), seal (8), reinforcement plate (10), seal (11), plate (12) and slave receptacle (4) from cab (9). Discard locknuts (14), lockwashers (15), and lockwashers (2). 7. Remove cover (13), two screws (6), washers (7), positive cable (22), and ground cable (5) from slave receptacle (4). 8. Remove positive cables (22), and ground cable (5) from cab (9). INSTALLATION 1. Install positive cables (22), and ground cable (5) on cab (9). 2. Install positive cable (22), and ground cable (5) on cab (9) with two screws (6), washers (7) and cover (13). 3. Install slave receptacle (4), slave receptacle cap (30), seal (8), reinforcement plate (10), seal (11), plate (12), with four screws (1), new lockwashers (2), new lockwashers (15), and new locknuts (14) on cab (9) 4. Install four screws (21) and locknuts (20) on slave receptacle (4) and reinforcement plate (10). 5. Install two grommets (24), positive cable (22), and ground cable (5) on cab floor (29). 6. Install ground cable (5), and positive cable (22) on cab back panel support (23) with screw (27) washer (26), lockwasher (25), and two clamps (24). 7. Install positive cables (22) and (34) on positive battery terminal (32) with screw (31) and nut (33). 8. Install ground cable (5) on rear battery support hanger (16) with screw (17), two lockwashers (18), and locknut (19). 9. Release parking brake and remove wheel chocks (TM 9-2320-361-10).