TM-9-2320-361-24-2 Field Maintenance Manual Volume 2 for M44A2 Series Trucks
Page 604 of 1144
TM 9-2320-361-24-2 0360 00 0360 00-2 BATTERY BOX HEATER PAD REPLACEMENT (Contd) HEATER PAD REMOVAL WARNING Accidental or intentional introduction of liquid contaminants into the environment is a violation of state, federal, and military regulations. Refer to Army POL (WP 0001 00) for information concerning storage, use, and disposal of these liquids. Failure to do so may result in damage to environment and health of personnel. NOTE • Prior to removal, close water manifold valve. • Use a drain pan to capture any draining coolant. Dispose of fluids in accordance with local policy and ordinances. Ensure all spills are cleaned up. 1. Loosen two clamps (6) and remove exhaust inlet hose (9) and outlet hose (7) from heater pad (1). 2. Remove heater pad (1) from battery box (3). BATTERY BOX REMOVAL 1. Remove two rubber grommets (2) from battery box (3) and battery cables. 2. Remove four screws (4), lockwashers (5), spacers (8), and battery box (3) from cab floor (10). Discard lockwashers (5). BATTERY BOX INSTALLATION 1. Install battery box (3) on cab floor (10), with four spacers (8), new lockwashers (5) and screws (4). 2. Install two rubber grommets (2) on battery cables and battery box (3). HEATER PAD INSTALLATION 1. Install heater pad (1) in battery box (3). 2. Install exhaust inlet hose (9) and outlet hose (7) on heater pad (1). Tighten clamps (6). 3. Install batteries (WP 0127 00). 4. Install companion seat (WP 0234 00). 5. Release parking brake and remove wheel chocks (TM 9-2320-361-10). END OF WORK PACKAGE 7 8 9 6 10 1 ~ 6 5 4 3 2