Covering the politics, Business and technology of defense - Subscribe Today
TM-9-2320-361-24-2 Page 550

TM-9-2320-361-24-2 Field Maintenance Manual Volume 2 for M44A2 Series Trucks

Page 550 of 1144


Download
TM 9-2320-361-24-2 0346 00 0346 00-2 FRONT WINCH PROPELLER SHAFT REPLACEMENT (Contd) END OF WORK PACKAGE 1 2 3 4 5 6 7 8 9 9 10 11 REMOVAL NOTE Place front winch control lever in low position to remove screws, then in neutral position to gain access to remaining screws. 1. Remove four screws (3), locknuts (1), and rear flange (11) from transmission power takeoff flange (2). Discard locknuts (1). 2. Remove two cotter pins (6), pin (5), propeller shaft (4), and yoke (8) from front winch shaft (7). 3. Slide rear yoke (10) off propeller shaft (4). INSPECTION Inspect two universal joints (9) for looseness or roughness. If damaged, replace universal joint (9) (WP 0141 00). INSTALLATION 1. Place a light coat of GAA grease on propeller shaft (4) splines and install rear yoke (10) and rear flange (11) on propeller shaft (4). 2. Install front yoke (8) and propeller shaft (4) on front winch shaft (7) and align pin (5) hole with front winch shaft (7) hole. Install pin (5) through front yoke (8) and winch shaft (7) and secure with two new cotter pins (6). 3. Install rear yoke (10) and rear flange (11) to transmission PTO flange (2) with four screws (3) and new locknuts (1). 4. Lubricate front winch propeller shaft (WP 0020 00). 5. Connect battery ground cable (WP 0126 00). 6. Release parking brake and remove wheel chocks (TM 9-2320-361-10).