TM-9-2320-361-24-2 Field Maintenance Manual Volume 2 for M44A2 Series Trucks
Page 503 of 1144
TM 9-2320-361-24-2 0329 00 0329 00-1/2 blank FIELD MAINTENANCE INSTRUCTIONS 2-1/2 TON, 6X6, M44A2 SERIES TRUCKS (MULTIFUEL) VAN BODIES FRONT SPLASH GUARD REPLACEMENT REMOVAL AND INSTALLATION INITIAL SETUP: Applicable Models M185A3, M109A3 Materials/Parts Eight locknuts (item 129, WP 0470 00) Equipment Condition Parking brake set and wheels chocked (TM 9-2320-361-10). Battery ground cable disconnected (WP 0126 00). NOTE Left and right front splash guards are removed the same, except for two additional screws for the pioneer tool bracket on the left side. This procedure is for the left front splash guard. REMOVAL 1. Remove two locknuts (6) and screws (3) from two braces (9) and frame (4). Discard locknuts (6). 2. Remove two locknuts (11), screws (8), and two braces (9) from splash guard (10). Discard locknuts (11). 3. Remove two locknuts (12) and screws (7) from pioneer tool bracket (13) and splash guard (10). Discard locknuts (12). 4. Remove two locknuts (1), screws (5), and splash guard (10) from frame (2). Discard locknuts (1). INSTALLATION 1. Install splash guard (10) on frame (2) with two screws (5) and new locknuts (1). 2. Install pioneer tool bracket (13) on splash guard (10) with two screws (7) and new locknuts (12). 3. Install two braces (9) on frame (4) with two screws (3) and new locknuts (6). 4. Install two braces (9) on splash guard (10) with two screws (8) and new locknuts (11). 5. Connect battery ground cable (WP 0126 00). 6. Release parking brake and remove wheel chocks (TM 9-2320-361-10). END OF WORK PACKAGE 3 2 1 4 6 8 9 10 13 11 12 5 9 7