TM-9-2320-361-24-2 Field Maintenance Manual Volume 2 for M44A2 Series Trucks
Page 438 of 1144
TM 9-2320-361-24-2 0315 00 0315 00-2 115- AND 24-VOLT WIRING HARNESS REPLACEMENT (Contd) CAUTION Use care when removing wiring harnesses. Excessive snagging or pulling may damage wires. NOTE Prior to removal, tag lead wires, cables, and terminals for installation. REMOVAL NOTE All three ceiling panels are removed the same. This procedure covers the removal of one ceiling panel. 1. Remove ten screws (3) and center ceiling panel (4) from van body ceiling (1). NOTE • Safety wire will be used to install new wiring harness. Do not cut safety wire from spool until harness has been pulled from van and proper length has been obtained. • Safety wire must be attached to wires with electrical tape. 2. Attach safety wire (8) to wires (7), (10), and (11). 3. Bend tabs (2) out of the way. 4. Pull wiring harness (6) out of van body rear wall (5). 5. Remove safety wire (8) from wires (7), (10), and (11). Cut safety wire (8) from spools (9).