TM-9-2320-361-24-2 Field Maintenance Manual Volume 2 for M44A2 Series Trucks
Page 418 of 1144
TM 9-2320-361-24-2 0309 00 0309 00-2 115-VOLT AC RECEPTACLE REPLACEMENT (Contd) CAUTION Use care when removing or installing wiring harness. Excessive snagging or pulling may damage wires. REMOVAL NOTE Prior to removal, tag lead wires and terminals for installation. 1. Slide handle (3) on safety switch box (2) to OFF position and open cover (5). NOTE Perform step 2 for M109A3 vehicles. 2. Loosen two screws (1) and remove two wires (4) from safety switch box (2). NOTE Perform step 3 for M185A3 vehicles. 3. Loosen two screws (7) and remove two wires (6) and two wires (4) from safety switch box (2). 4. Using electrical tape, attach safety wire (8) to two wires (4). 5. Remove four screws (11), receptacle (10), wires (4), and gasket (9) from van body (12). Discard gasket (9). 6. Remove safety wire (8) from two wires (4). INSTALLATION 1. Using electrical tape, attach safety wire (8) to two wires (4). NOTE Assistant will help with step 2. 2. Pull safety wire (8) and two wires (4) through van body (12). 3. Install new gasket (9) and receptacle (10) on van body (12) with four screws (11). 4. Remove safety wire (8) from two wires (4). NOTE Perform step 5 for M185A3 vehicles. 5. Install two wires (4) and two wires (6) on safety switch box (2) by tightening two screws (7). NOTE Perform step 6 for M109A3 vehicles. 6. Install two wires (4) on safety switch box (2) by tightening two screws (1). 7. Close cover (5) on safety switch box (2) and slide handle (3) to ON position. 8. Connect battery ground cable (WP 0126 00). 9. Release parking brake and remove wheel chocks (TM 9-2320-361-10).