TM-9-2320-361-24-2 Field Maintenance Manual Volume 2 for M44A2 Series Trucks
Page 342 of 1144
TM 9-2320-361-24-2 0285 00 0285 00-2 SEPARATOR ELEMENT TEST VALVE, GAUGE, AND LINES MAINTENANCE(M49A2C) (Contd) WARNING Diesel fuel is flammable. Do not perform fuel system procedures near open flames. Injury or death to personnel may result. REMOVAL 1. Remove two tubes (14), line (15), five adapters (3), and elbow (11) from filter separator (1) and selector valve (9). 2. Remove two locknuts (10), screws (6), instruction plate (7), and selector valve (9) from bracket (8). Discard locknuts (10). 3. Remove two locknuts (16), screws (5), and bracket (8) from shelf (2). Discard locknuts (16). 4. Remove gauge (12) from elbow (13) and elbow (13) from selector valve (9). INSPECTION Clean and inspect fittings (4) for cracks or stripped threads. Replace fittings (4) if threads are cracked or stripped. INSTALLATION NOTE Male pipe threads must be wrapped with antiseize tape before installation. 1. Install elbow (13) on selector valve (9). 2. Install gauge (12) on elbow (13). 3. Install bracket (8) on shelf (2) with two screws (5) and new locknuts (16). 4. Install selector valve (9) and instruction plate (7) on bracket (8) with two screws (6) and new locknuts (10). 5. Install elbow (11), five adapters (3), line (15), and two tubes (14) on filter separator (1) and selector valve (9). 6. Fill filter separator (TM 9-2320-361-10). 7. Connect battery ground cable (WP 0126 00). 8. Release parking brake and remove wheel chocks (TM 9-2320-361-10).