TM-9-2320-361-24-2 Field Maintenance Manual Volume 2 for M44A2 Series Trucks
Page 338 of 1144
TM 9-2320-361-24-2 0283 00 0283 00-2 GATE VALVE REPLACEMENT (Contd) WARNING • Diesel fuel is flammable. Do not perform fuel system procedures near open flames. Injury or death to personnel may result. • Accidental or intentional introduction of liquid contaminants into the environment is a violation of state, federal, and military regulations. Refer to Army POL (WP 0001 00) for information concerning storage, use, and disposal of these liquids. Failure to do so may result in damage to environment and health of personnel. NOTE • Use a drain pan to capture any draining fuel. Dispose of fluids in accordance with local policy and ordinances. Ensure all spills are cleaned up. • Both gate valves are removed the same way. REMOVAL 1. Remove four locknuts (9), screws (7), cover (6), and gasket (8) from gate valve (1). Discard locknuts (9) and gasket (8). Remove gasket remains from mating surfaces. 2. Remove four locknuts (2), screws (5), valve (1), and gasket (4) from manifold flange (3). Discard locknuts (2) and gasket (4). Remove gasket remains from mating surfaces. INSTALLATION 1. Install new gasket (4) and valve (1) on manifold flange (3) with four screws (5) and new locknuts (2). 2. Install new gasket (8) and cover (6) on valve (1) with four screws (7) and new locknuts (9). 3. Connect battery ground cable (WP 0126 00). 4. Release parking brake and remove wheel chocks (TM 9-2320-361-10). 2 3 4 6 7 1 5 8 END OF WORK PACKAGE 9