TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 924 of 1176
TM 9-2320-361-24-1 0141 00 0141 00-6 UNIVERSAL JOINT MAINTENANCE (Contd) NOTE Align marks on yokes before assembling bearing caps in shaft yoke. 2. Cap type: a. Install four new seals (8) on universal joint journals (9). b. Install lubrication fitting (10) on universal joint (7). c. Install universal joint (7) in upper yoke flange loop (5) with lubrication fitting (10) angled away from yoke flange (6). d. Apply GAA grease in bearing caps (3) to hold bearing (4) in place during assembly. e. Install two bearing caps (3) on universal joint journal (9) and upper yoke flange loop (5). f. Position two locking straps (2) on bearing caps (3) and install with four screws (1). Tighten screws (1) 18–25 lb-ft (24–34 N•m). Bend tabs of locking straps (2) up to hold screws (1) in place. NOTE • Align marks on yokes before assembling bearing caps in shaft yoke. • Shaft yoke and yoke flange should move smoothly and have no free play. g. Position shaft yoke (11) on universal joint journals (9) and install two bearing caps (3) with new locking straps (2) and four screws (1). Tighten screws (1) 18–25 lb-ft (24–34 N•m). h. Bend tabs of locking straps (2) up to hold screws (1) in place. 3. Install propeller shaft (WP 0139 00). 4. Install intermediate propeller shaft (M36A2) (WP 0140 00). END OF WORK PACKAGE 8 9 10 7 CAP TYPE 1 2 3 4 5 6 7 1 2 3 6 9 1 2 3 11 10