TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 827 of 1176
TM 9-2320-361-24-1 0121 00 0121 00-1/2 blank REMOVAL 1. Remove amber lens (4), red lens (1), two O-rings (2), and lamp (3) from bracket (14). Discard O-rings (2). 2. Disconnect wire (13) from connector (12). 3. Remove nut (5), lockwasher (6), washer (15), and bracket (14) from brush guard (7). Discard lockwasher (6). 4. Remove two screws (11), lockwashers (10), nuts (9), and brush guard (7) from bracket (8). Discard lockwashers (10). INSTALLATION 1. Install brush guard (7) on bracket (8) with two screws (11), new lockwashers (10), and nuts (9). 2. Install bracket (14), washer (15), new lockwasher (6), and nut (5) on brush guard (7). 3. Connect wire (13) to connector (12). 4. Install lamp (3), two new O-rings (2), red lens (1), and amber lens (4) on bracket (14). 5. Connect battery ground cable (WP 0126 00). 6. Check operation of intermediate turn signal light (TM 9-2320-361-10). 7. Release parking brake and remove wheel chocks (TM 9-2320-361-10). FIELD MAINTENANCE INSTRUCTIONS 2-1/2 TON, 6X6, M44A2 SERIES TRUCKS (MULTIFUEL) INTERMEDIATE TURN SIGNAL REPLACEMENT REMOVAL AND INSTALLATION INITIAL SETUP: Applicable Models All Materials/Parts Lockwasher (item 220, WP 0470 00) Two lockwashers (item 195, WP 0470 00) Two O-rings (item 283, WP 0470 00) Equipment Condition Parking brake set and wheels chocked (TM 9-2320-361-10). Battery ground cable disconnected (WP 0126 00). END OF WORK PACKAGE 1 2 3 2 4 6 7 8 11 12 13 14 15 9 10 5