TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 756 of 1176
TM 9-2320-361-24-1 0095 00 0095 00-2 OIL PRESSURE GAUGE, BATTERY AND ALTERNATOR GAUGE, FUEL GAUGE, AND ENGINE TEMPERATURE GAUGE REPLACEMENT (Contd) CAUTION The 60 psi and 120 psi gauges and sending units are not interchangeable. Installation of improper gauge may result in damage to equipment. NOTE Engine temperature, oil pressure, battery and alternator, and fuel gauges are removed and installed the same. This procedure covers the engine temperature gauge. REMOVAL 1. Turn four lockstuds (5) ΒΌ turn to left and pull instrument cluster (7) away from instrument panel (8). NOTE Prior to removal, tag lead wires for installation. 2. Disconnect lead wires (1) and (9) from engine temperature gauge (6). 3. Remove two nuts (2), lockwashers (3), and bracket (4) from temperature gauge (6). Discard lockwashers (3). 4. Remove engine temperature gauge (6) from instrument cluster (7). INSTALLATION 1. Position engine temperature gauge (6) through front of instrument cluster (7). 2. Install bracket (4) on temperature gauge (6) with two new lockwashers (3) and nuts (2). 3. Connect lead wires (1) and (9) to engine temperature gauge (6). 4. Position instrument cluster (7) on instrument panel (8) and install by turning four lockstuds (5) 1/4 turn to right. 5. Connect battery ground cable (WP 0126 00). 6. Start engine (TM 9-2320-361-10) and check gauges for proper operation. 7. Release parking brake and remove wheel chocks (TM 9-2320-361-10).