Covering the politics, Business and technology of defense - Subscribe Today
TM-9-2320-361-24-1 Page 728

TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks

Page 728 of 1176


Download
TM 9-2320-361-24-1 0091 00 0091 00-8 FRONT WIRING HARNESS REPLACEMENT (Contd) REMOVAL (Contd) 51. Disconnect wires (10) and (11) from stoplight switch (12). 52. Remove two locknuts (14), screws (13), front wiring harness (1), and horn rear wiring harness (15), from brace (16). Discard locknuts (14). 53. Remove two locknuts (2), screws (8), and clamps (3) from brace (4), front wiring harness (1), and frame (9). Discard locknuts (2). 54. Remove nut (5) and clamp (7) from front wiring harness (1) and U-bolt (6). CAUTION Use care when removing front wiring harness. Snagging and pulling may cause damage to harness. 55. Remove front wiring harness (1) from left side frame (17), right side frame (18), over steering column (19), and through firewall (21). INSTALLATION CAUTION Use care when routing front wiring harness. Snagging and pulling may cause damage to front wiring harness. NOTE • If new wiring harness is to be installed, remove tags from old harness and install on new harness. • For additional wiring harness installation information, refer to Electrical System Wiring Diagram (WP 0473 00). 1. Install front wiring harness (1) through firewall (21), over steering column (19), left side frame (17), and right side frame (18), and under cab (20). 2 3 3 4 5 6 7 8 9 10 11 12 13 14 15 16 1