TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 692 of 1176
TM 9-2320-361-24-1 0083 00 0083 00-2 OIL COOLER TUBE AND HOSE REPLACEMENT (Contd) WARNING Accidental or intentional introduction of liquid contaminants into the environment is a violation of state, federal, and military regulations. Refer to Army POL (WP 0001 00) for information concerning storage, use, and disposal of these liquids. Failure to do so may result in damage to environment and health of personnel. NOTE Use a drain pan to capture any draining oil. Dispose of fluids in accordance with local policy and ordinances. Ensure all spills are cleaned up. REMOVAL 1. Loosen four clamps (2) on two hoses (3). 2. Remove oil cooler tube (5), two hoses (3), and four clamps (2) from water pump (1) and engine oil cooler (4). INSTALLATION 1. Install oil cooler tube (5) and two hoses (3) on water pump (1) and engine oil cooler (4) with four clamps (2). 2. Tighten four clamps (2) on two hoses (3). 3. Fill cooling system (WP 0076 00). 4. Connect battery ground cable (WP 0126 00). 5. Lower and secure hood (TM 9-2320-361-10). 6. Release parking brake and remove wheel chocks (TM 9-2320-361-10). ~ 3 3 1 4 2 2 END OF WORK PACKAGE 5