TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 678 of 1176
TM 9-2320-361-24-1 0079 00 0079 00-2 PERSONNEL HEATER INLET AND OUTLET HOSE REPLACEMENT (Contd) REMOVAL 1. Remove locknut (9), screw (7), two clamps (1), inlet hose (3), and outlet hose (5) from bracket (2). Discard locknut (9). WARNING • Do not remove inlet hose or outlet hose when engine is hot. Steam or hot coolant under pressure may cause injury to personnel. • Accidental or intentional introduction of liquid contaminants into the environment is a violation of state, federal, and military regulations. Refer to Army POL (WP 0001 00) for information concerning storage, use, and disposal of these liquids. Failure to do so may result in damage to environment and health of personnel. NOTE Use a drain pan to capture any draining coolant. Dispose of fluids in accordance with local policy and ordinances. Ensure all spills are cleaned up. 2. Loosen four clamps (4) and remove inlet hose (3) and outlet hose (5) from heater (6), water pump (8), and intake manifold (10). 3. Remove four clamps (4) and two clamps (1) from inlet hose (3) and outlet hose (5). INSTALLATION 1. Install two clamps (1) and four clamps (4) on inlet hose (3) and outlet hose (5). Do not tighten clamps (4). 2. Install inlet hose (3) and outlet hose (5) on heater (6), water pump (8), and intake manifold (10). Tighten four clamps (4). 3. Install two clamps (1), inlet hose (3), and outlet hose (5) on bracket (2) with screw (7), and new locknut (9).