TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 648 of 1176
TM 9-2320-361-24-1 0073 00 0073 00-4 EXHAUST SYSTEM REPLACEMENT (ALL EXCEPT M50A3) (Contd) INSTALLATION 1. Install exhaust pipe (29) on fender (32). 2. Install exhaust pipe (29) on bracket (16) with U-bolt (35), clamp (17), two new lockwashers (6), and nuts (5). 3. Install exhaust pipe (29) on bracket (25) with clamp (26), washer (27), screw (28), washer (19), and new locknut (20). 4. Install cover plates (18) on fender (32) with two washers (33), screws (34), washers (31), and two new locknuts (30). 5. Install exhaust shield (36) on exhaust pipe (29) with two clamps (3), four screws (37), and new locknuts (4). 6. Install new gasket (40) and stack pipe (1) on exhaust pipe (29) with coupling (39), screw (38), and new locknut (2). Do not tighten locknut (2). 7. Position outlet of stack pipe (1) outward and approximately 45° to rear of vehicle. Tighten coupling (39). 8. Install new gasket (24) and flex tube (15) on exhaust pipe (29) with coupling (23), screw (21), and new locknut (22). Do not tighten locknut (22). 9. Install new gasket (10) and elbow (9) on turbocharger (12) with clamp (11). Do not tighten clamp (11). 10. Install new gasket (8) and flex tube (15) on elbow (9) with coupling (14), screw (7), and new locknut (13). Tighten coupling (14). 11. Tighten clamp (11) and coupling (23). 12. Install air cleaner element (WP 0052 00). 13. Connect battery ground cable (WP 0126 00). 14. Start engine (TM 9-2320-361-10). 15. Lower and secure hood (TM 9-2320-361-10). 16. Release parking brake and remove wheel chocks (TM 9-2320-361-10).