TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 615 of 1176
TM 9-2320-361-24-1 0068 00 0068 00-3/4 blank FUEL INJECTOR TUBES MAINTENANCE (Contd) END OF WORK PACKAGE INSTALLATION (Contd) 1. Install three fuel injector tubes (21), (22), and (24) on fuel injector nozzles (3) with three nuts (26). 2. Install three fuel injector tubes (21), (22), and (24) on fuel injection pump (14) ports no. 2, no. 6, and no. 4 respectively with three nuts (15). Do not tighten nuts (15). 3. Install two retainer halves (17) and three fuel injector tubes (21), (22), and (24) on bracket (19) with two screws (25), washers (9), and new locknuts (18). 4. Install two clamps (20) on brackets (1) with screws (23) and new locknuts (2). 5. Install three fuel injector tubes (21), (22), and (24) on fuel injector nozzles (3) with three nuts (26). Tighten nuts (26) 23–25 lb-ft (31–34 N•m). 6. Tighten nuts (15) 23–25 lb-ft (31–34 N•m) and lower dust caps (16) over nuts (15). 7. Install three fuel injector tubes (4), (5), and (6) on fuel injector pump (14) ports no. 3, no. 5, and no. 1 respectively with three nuts (15). Do not tighten nuts (15). 8. Install three fuel injector tubes on injector nozzles (3) with three nuts (26). Do not tighten nuts (26). 9. Install eight retainer halves (8) and cushion halves (7) on fuel injector tubes (4), (5), and (6) with four screws (10), washers (9), and new locknuts (27). 10. Install washer (9), two retainer halves (17), and fuel injector tubes (4), (5), and (6) on stud (13) with new lockwasher (12) and nut (11). 11. Tighten three nuts (15) and (26) 23–35 lb-ft (31–34 N•m). 12. Lower dust cabs (16) over nuts (15). 13. Bleed fuel system (WP 0064 00). 14. Connect battery ground cable (WP 0126 00). 15. Lower and secure hood (TM 9-2320-361-10). 16. Release parking brake and remove wheel chocks (TM 9-2320-361-10). NO. 1 NO. 5 NO. 6 NO. 4 NO. 2 NO. 3 4 5 7 6 3 2 1 1 22 20 24 25 17 26 8 27 11 12 10 9 8 7 9 9 13 14 15 16 17 18 19 20 21 17 23