TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 578 of 1176
TM 9-2320-361-24-1 0061 00 0061 00-8 FUEL PUMP (IN-TANK) MAINTENANCE (Contd) INSTALLATION NOTE If new fuel pump is installed, measurement “A” must be 15.1 in. (38.4 cm). If necessary to adjust fuel pump length, perform steps 1 through 5. 1. Remove pump (8) from clamp (12). 2. Remove two nuts (11), washers (10), and screws (7) from clamp (12) and fuel pump bracket (6). 3. Install pump (8) on clamp (12) and position pump (8) up or down in fuel pump bracket (6) to give correct measurement. 4. Remove pump (8) from clamp (12) and install two screws (7), washers (10), and nuts (11) on fuel pump bracket (6) and clamp (12). 5. Install pump (8) in clamp (12). 6. Install new gasket (9) and fuel pump assembly (5) on fuel tank (13) with ten screws (1). 7. Install fuel tank (WP 0060 00). NOTE Male pipe threads must be wrapped with antiseize tape before installation. 8. Connect fuel supply tube (4) to fuel pump assembly (5). 9. Install elbow (2) on fuel pump assembly (5) and connect vent tube (3) to elbow (2). WARNING Some vehicles have two separate wires and connectors. Connecting wires on wrong terminals may cause fuel to ignite, resulting in injury to personnel and/or damage to equipment. 10. Connect connector (15) to terminal cover (14). 11. Connect battery ground cable (WP 0126 00). 12. Start engine (TM 9-2320-361-10), check operation of fuel pump, and check for fuel leaks. 13. Release parking brake and remove wheel chocks (TM 9-2320-361-10). END OF WORK PACKAGE A 3 4 5 2 1 15 14 13 12 11 10 8 7 6 9