TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 515 of 1176
TM 9-2320-361-24-1 0046 00 0046 00-15 ENGINE REPLACEMENT (Contd) INSTALLATION (Contd) WARNING Keep hands clear of supported engine during placement of engine mounts. Failure to do so may result in injury to personnel. 13. Position two mounting pads (20) and (31) on frame (23) and crossmember (30). 14. Lower engine (1) until it rests on frame (23) and crossmember (30). Ensure mounting holes are aligned. 15. Install two washers (32), screws (33), lower mounting pads (29), washers (28), and new locknuts (27) on support plate (10) and crossmember (30). Tighten locknuts (27) 65–70 lb-ft (88–95 N•m). 16. Install two washers (18), screws (17), lower mounting pads (24), washers (25), and new locknuts (26) on frame (23). Finger-tighten locknuts (26). 17. Tighten locknuts (26) 65–70 lb-ft (88–95 N•m). 18. Remove lifting device and sling from chain and front lifting bracket (11). 19. Remove nut (15), screw (12), washers (14) and (13), and chain from rear mounting bracket (16). NOTE Perform step 20 if vehicle is equipped with transmission PTO. 20. Position clevis (22) on PTO arm (19) and push pin (21) in clevis (22) until head of pin (21) seats against clevis (22). LIFTING DEVICE SLING 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 10 32 33 1 11 12 13