TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 456 of 1176
TM 9-2320-361-24-1 0035 00 0035 00-2 OIL PAN REPLACEMENT (Contd) WARNING Accidental or intentional introduction of liquid contaminants into the environment is a violation of state, federal, and military regulations. Refer to Army POL (WP 0001 00) for information concerning storage, use, and disposal of these liquids. Failure to do so may result in damage to environment and health of personnel. NOTE Use a drain pan to capture any draining oil. Dispose of fluids in accordance with local policy and ordinances. Ensure all spills are cleaned up. REMOVAL 1. Place hydraulic jack under driver’s side front axle (4) and raise vehicle. 2. Place jack stand under driver’s side frame (1) and lower hydraulic jack. 3. Remove thirty screws (6), lockwashers (7), oil pan (8), and gasket (5) from engine block (3) and timing cover (2). Discard lockwashers (7) and gasket (5). 4. Remove gasket remains from oil pan (8), engine block (3), and timing cover (2). INSTALLATION 1. Apply light coat of sealing compound to new gasket (5). 2. Install new gasket (5) and oil pan (8) on engine block (3) and timing cover (2) with thirty new lockwashers (7) and screws (6). 3. Place hydraulic jack under driver’s (left) side front axle (4) and raise vehicle. 4. Remove jack stand from under frame (1). 5. Lower vehicle and remove hydraulic jack. 6. Fill engine with oil (WP 0020 00). 7. Connect battery ground cable (WP 0126 00). 8. Lower and secure hood (TM 9-2320-361-10). 9. Release parking brake and remove wheel chocks (TM 9-2320-361-10).