TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 446 of 1176
TM 9-2320-361-24-1 0032 00 0032 00-2 TIMIMG GEARS COVER AND GASKET REPLACEMENT (Contd) Water pump and housing removed (WP 0082 00). REMOVAL 1. Remove nut (21) and lockwasher (20) from timing cover stud (23). Discard lockwasher (20). 2. Remove four nuts (12), lockwashers (11), screws (22), access cover (19), and gasket (18). Discard lockwashers (11) and gasket (18). 3. Remove seven screws (25) and lockwashers (24) from adapter plate (13) and timing cover (4). Discard lockwashers (24). 4. Remove nut (8), lockwasher (7), nut (10), lockwasher (9), and screws (1) and (26) from adapter plate (13) and timing cover (4). Discard lockwashers (7) and (9). 5. Remove nut (2) and lockwasher (3) from timing cover (4) and stud (6). Discard lockwasher (3). 6. Remove four screws (16) and lockwashers (17) from timing cover (4) and oil pan (14). Discard lockwashers (17). CAUTION Oil pan gasket may stick to timing cover. Use care when removing timing cover from oil pan. Failure to do this may damage oil pan gasket. 7. Remove timing cover (4) and gasket (5) from adapter plate (13) and oil pan gasket (15). Discard gasket (5). 8. Remove all remaining gasket (5) material from timing cover (4) and adapter plate (13). INSTALLATION 1. With new gasket (5) laying flat on timing cover (4), trim bottom edges of gasket (5) even with bottom edge of timing cover (4). 2. Apply a thin, even coat of gasket sealing compound on both sides of timing cover gasket (5) and exposed surface of oil pan gasket (15). 3. Apply a thin coat of thread locking sealing compound on threads of seven screws (25). 4. Install gasket (5) and timing cover (4) on adapter plate (13) with seven new lockwashers (24) and screws (25). 5. Install screws (1) and (26) through timing cover (4) and adapter plate (13) with new lockwashers (7) and (9) and nuts (8) and (10). 6. Install new lockwasher (3) and nut (2) on stud (6) and timing cover (4). 7. Install timing cover (4) on oil pan (14) with four new lockwashers (17) and screws (16). 8. Install new gasket (18) and access cover (19) on timing cover (4) with new lockwasher (20), nut (21), four screws (22), new lockwashers (11), and nuts (12). 9. Install water pump and housing (WP 0082 00). 10. Install tachometer cable adapter (WP 0098 00). 11. Install vibration damper (WP 0028 00). 12. Connect battery ground cable (WP 0126 00). 13. Lower and secure hood (TM 9-2320-361-10).