TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 416 of 1176
TM 9-2320-361-24-1 0027 00 0027 00-6 CYLINDER HEAD MAINTENANCE (Contd) INSTALLATION (Contd) WARNING Ensure engine compartment is free of all tools and working materials before starting engine. Failure to do this may result in damage to equipment and injury to personnel. 11. Start engine (TM 9-2320-361-10). Idle engine until coolant temperature reaches a minimum of 175 °F (79 °C) before engine shutdown. NOTE It is not recommended to hot re-torque this gasket. If any seepage or leaks occur, a re-torque is required. It must be done on a cold engine. Re-torque using torque sequence shown, tighten nuts (12) to 157 lb-ft (204 N•m). 12. Remove no. 1 through no. 3 injector tubes (WP 0068 00). 13. Remove rocker arm cover and gasket (WP 0030 00). 14. Remove rocker arm assembly (WP 0031 00). 15. Install pushrods and rocker arm assembly, and adjust valve clearance (WP 0031 00). 16. Install rocker arm cover and gasket (WP 0030 00). 17. Install injector tubes (WP 0068 00). 18. Install fuel injector nozzles and holders (WP 0067 00). 19. Install air intake tube and cap (WP 0051 00). 20. Connect battery ground cable (WP 0126 00). 21. Lower and secure hood (TM 902320-361-10). 22. Release parking brake and remove wheel chocks (TM 9-2320-361-10).