TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 353 of 1176
TM 9-2320-361-24-1 0020 00 0020 00-1 FIELD MAINTENANCE INSTRUCTIONS 2-1/2 TON, 6X6, M44A2 SERIES TRUCKS (MULTIFUEL) LUBRICATION INSTRUCTIONS GENERAL The lubrication instructions include table 1, Fluid Capacities and Lubricant Requirements, and table 2, Lubrication Intervals and Locations. Table 2 is used for lubricating vehicles under normal operating conditions. SERVICE INTERVALS Service intervals are for normal operation of the vehicle in moderate temperatures, humidity, and atmospheric conditions. The intervals are hard-time intervals performed in accordance with the vehicle’s age, calendar, or usage such as operating time or mileage. The hard-time intervals in table 2 are based on mileage and calendar times. An example of mileage and calendar intervals is: 6/A; 6 stands for 6,000 miles (9,656 km) and A stands for annually (every twelve months). The lubrication for the vehicle is to be performed at whichever interval occurs firsts. Hard-time oil service intervals must be followed for equipment under manufacturer’s warranty. Hard- time intervals may be shortened if lubricants are used under adverse conditions, including longer than usual operating hours. Hard-time intervals may be extended during periods of low activity, although adequate preservation precautions must be taken. Service intervals under abnormal conditions will increase the frequency of lubricating service, such as high or low temperatures, prolonged high-speed driving, or extended cross-country operations. These conditions can diminish a lubricant’s protective quality. ARCTIC CONDITIONS Refer to FM 9-207, Operation and Maintenance of Ordnance Materiel in Cold Weather 0 to -65 °F (-18 to -54 °C), or table 1, Fluid Capacities and Lubricant Requirements. CORROSION PREVENTION AND CONTROL (CPC) Corrosion prevention and control (CPC) of Army material is a continuing concern. It is important that corrosion problems are reported so that corrections and improvements can be made to prevent future problems. While corrosion is typically associated with rusting of metals, it can also include deterioration of other materials, such as rubber and plastic. Unusual cracking, softening, swelling, or breaking of these materials may be a corrosion problem. If a corrosion problem is identified, it can be reported using SF 368, Product Quality Deficiency Report. Use of key words such as corrosion, rust, deterioration, or cracking will ensure that the information is identified as a CPC problem. This form should be submitted to the address specified in DA Pam 738-750.