TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 351 of 1176
TM 9-2320-361-24-1 0019 00 0019 00-1 FIELD MAINTENANCE INSTRUCTIONS 2-1/2 TON, 6X6, M44A2 SERIES TRUCKS (MULTIFUEL) SERVICE UPON RECEIPT GENERAL Upon receipt of a new, used, or reconditioned vehicle, refer to TM 9-2320-361-10 and perform the following steps to determine if the vehicle has been properly prepared for service. NOTE The operator will assist when performing service-upon-receipt inspections. 1. Inspect all assemblies, subassemblies, and accessories to ensure they are in proper working order. 2. Secure, clean, lubricate, or adjust equipment as indicated in the Preventive Maintenance Checks and Services (PMCS) (WP 0023 00). 3. Check all Basic Issue Items (BII) to ensure every item is present, in good condition, and properly mounted or stowed. GENERAL INSPECTION AND SERVICING INSTRUCTIONS Refer to TM 9-2320-361-10 and other WPs in this manual when servicing, inspecting, and lubricating equipment. WARNING Skysol 100 mixture is combustible; DO NOT use or store near heat, sparks, flame, or other ignition sources. Use mechanical ventilation whenever product is used in a confined space, heated above ambient temperatures, or agitated. Keep container sealed when not in use. Failure to do so may result in injury to personnel. Contact with Skysol 100 may cause skin irritation. Use chemical-resistant gloves. In case of skin contact, remove any contaminated clothing and wash skin thoroughly with soap and water. Wash contaminated clothing before reuse. Eye contact may cause irritation, tearing, or blurring of vision. Use face shield or goggles when eye contact may occur. In case of eye contact, flush eyes with large amounts of water for at least 15 minutes or until irritation subsides. Inhalation may cause irritation to upper respiratory passages. DO NOT have food or drink in the vicinity. Failure to do so may result in injury to personnel. NOTE If the vehicle was driven to the using organization, the following steps should have been completed. 1. Use Skysol 100 to clean all exterior surfaces coated with rust-preventive compounds. 2. Read Processing and Deprocessing Record of Shipping, Storage, and Issue of Vehicles and Spare Engines tag (DD Form 1397), and follow all precautions listed. This tag should be attached to steering wheel, shift column, or battery switch.