TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 278 of 1176
TM 9-2320-361-24-1 0016 00 0016 00-8 SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE—REPROGRAMMABLE (STE/ICE-R) TROUBLESHOOTING INTRODUCTION (Contd) Table 3. Error Messages. VTM READOUT INTERPRETATION E000 Technician has requested information that the VTM it does not have; for example, if the technician requests the VID number and it has not yet been entered. E001 Nonexistent test number has been dialed into TEST SELECT switches. E002 Required transducer is not connected. E004 VID number or number of cylinders has not been entered. E005 Transducer offset test was not performed. E007* Conflict between VID number dialed in and the number of cylinders dialed in. E008 VTM is not receiving required voltage signal for test selected. This error code is related only to starter and compression balance tests. E009 Engine is not running at start of test. E010* Wrong VID number has been entered. E011 Throttle control was operated incorrectly during power test, taking too much time to accelerate or decelerate. E012 CI pulse tachometer is missing. E013 Bad data has been taken for the test in progress. Repeat test one time. E014* Wrong number of cylinders has been dialed into VTM. E015* No longer used. If E015 appears, turn in VTM for update. E017 Engine is not running, or ignition adapter is broken or not properly connected. E018 Engine RPM or AC frequency test was terminated automatically to protect VTM. Termination is only after several minutes of no-signal operation. Most likely, VTM was left on vehicle and engine stalled. E020 No first peak was detected by VTM during peak-to-peak voltage test. E021 VTM cannot calculate results. Current is over current probe’s range and VTM did not sample correct portion of data. E022 External voltage was detected in circuit tested while measuring resistance. E023 VTM’s constant voltage source is not working. NOTE If any error message not listed below is displayed, return STE/ICE-R set to field maintenance for repair.