TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 272 of 1176
TM 9-2320-361-24-1 0016 00 0016 00-2 SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE—REPROGRAMMABLE (STE/ICE-R) TROUBLESHOOTING INTRODUCTION (Contd) The STE/ICE-R includes the following equipment: 1. The Vehicle Test Meter (VTM) is a tool for testing electrical and mechanical components. 2. Test Cards are attached to the front of the VTM to provide a quick but limited reference for the mechanic. Test cards list test numbers, messages, and some test procedures. 3. The Transit Case is a portable, protective case that houses the STE/ICE-R equipment and all necessary accessories. A pressure relief valve located on the front of the case allows the operator to release any pressure or vacuum resulting from changes in climate during transit. 4. Cable assemblies are included for power supply and testing. Cables assemblies are referred to by a name that describes how the cable is used. If necessary, two transducer cables (W4) can be joined with the adapter supplied in the transducer kit to make one long cable. When cables are connected, the large key on the cable connector mates with a keyway on the transducer connector or VTM connector for proper installation. If a cable is suspected to be damaged, refer to TM 9-4910-571-12&P for checking cable continuity. 5. The Test Probe Kit contains a variety of clips and probes, which can be attached to the test probe cable W2. These clips and probes allow the user to take different types of measurements (e.g., cable continuity tests, battery tests) with greater ease. 6. The Transducer Kit (TK) is a covered tray inside the transit case that contains necessary equipment to perform various electrical and diagnostic testing. 7. TM 9-4910-571-12&P describes the operation and organizational maintenance of the STE/ICE-R system.