TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 194 of 1176
MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION 1. STARTER WILL NOT CRANK (Contd) Test 3. Test for battery voltage into power accessory switch pins A and C. 1. Remove two leads 11 from power accessory switch pins A and C. Using multimeter, check for battery voltage on contact ends of leads 11. 2. Observe voltmeter in dash for proper operation. 3. Remove leads 27 from pin B of power accessory switch. With power accessory switch turned on, check for battery voltage at pin B. 1. If voltage is not present, go to test 5. 2. If voltage is present, install both leads 11 into pins A and C and go to test step 2. 1. If voltmeter works, go to test step 5. 2. If voltmeter does not work, go to test step 3. 1. If voltage is present, go to test step 5. 2. If voltage is not present, go to step 4. TM 9-2320-361-24-1 0012 00 0012 00-10 BATTERY AND CHARGING SYSTEM TROUBLESHOOTING (Contd) Table 2. Starting System Troubleshooting Procedure (Contd).