TM-9-2320-361-24-1 Field Maintenance Manual Volume 1 for M44A2 Series Trucks
Page 1046 of 1176
TM 9-2320-361-24-1 0166 00 0166 00-2 PARKING BRAKE LEVER REPLACEMENT (Contd) REMOVAL 1. Release parking brake if applied (refer to TM 9-2320-361-10). 2. Remove cotter pin (4), washer (3), and clevis pin (15) from cable clevis (12) and parking brake lever (1). Discard cotter pin (4). 3. Remove four nuts (6) and bracket (10) from cab floor (9) and two parking brake lever mounting brackets (7). NOTE Assistant will help with step 4. 4. Remove nut (11), screw (8), and parking lever (1) from cab floor (9). 5. Remove nut (5), screw (13) and spacer (2) from two parking brake lever mounting brackets (7). 6. Remove two nuts (14), screws (16), and parking brake lever mounting brackets (7) from parking lever (1). INSTALLATION NOTE Ensure parking brake lever adjusting knob is turned counterclockwise to lower link for installation. 1. Install two parking brake lever mounting brackets (7) on parking brake lever (1) with two screws (16) and nuts (14). Do not tighten nuts (14). 2. Install spacer (2) and screw (13) between two parking brake lever mounting brackets (7) and parking brake lever (1) with nut (5). Tighten nuts (5) and (14) so parking brake lever (1) moves freely. NOTE Assistant will help with step 3. 3. Install parking brake lever (1) on cab floor (9) with screw (8) and nut (11). 4. Install bracket (10) on cab floor (9) and two parking brake lever mounting brackets (7) with four nuts (6). 5. Connect parking brake lever (1) to cable clevis (12) with clevis pin (15), washer (3), and new cotter pin (4). 6. Adjust parking brake lever (TM 9-2320-361-10). 7. Connect battery ground cable (WP 0126 00). 8. Remove wheel chocks (TM 9-2320-361-10).