TM 9-2320-361-20 Section Il. POWER TAKEOFF CONTROLS AND LINKAGE MAINTENANCE 13-19. POWER TAKEOFF CONTROLS AND LINKAGE MAINTENANCE INDEX PARA. NO. TITLE PAGE NO. 13-20. Transmission Power Takeoff (PTO) Shift Linkage 13-34 Maintenance 13-21. Power Divider Propeller Shaft Replacement (M764) 13-36 13-22. Hydraulic Hoist Control Linkage Maintenance 13-38 (M342A2) 13-23. Power Divider Control Lever and Linkage Replacement 13-40 (M764) 13-20. TRANSMISSION POWER TAKEOFF (PTO) SHIFT LINKAGE MAINTENANCE This task covers: a. Removal c. Adjustment b. Inspection d. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Three locknuts EQUIPMENT CONDITION Cotter pin Parking brake set (TM 9-2320-361-10). Screw-assembled lockwasher 1. Remove screw-assembled lockwasher (4) from vehicle floor (6) and open master cylinder access door (5). Discard screw-assembled lockwasher (4). 2. Remove two locknuts (3), screws (2), and hinge lock (1) from cab floor (6). Discard locknuts (3). 3. Remove cotter pin (10) and clevis pin (18) from shift rod (12) and transmission PTO lever (19) and clevis (11). Discard cotter pin (10). 4. Remove locknut (9), screw (8), and transmission PTO lever (19) from support (21). Discard locknut (9). 5. Remove two screws (7) and support (21) from master cylinder (20). 6. Pull clevis pin (17) out far enough to allow shifting rod (12) to be removed from PTO arm (14). 7. Remove clevis pin (17), ball (15), and spring (16) from clevis (13). Remove shift rod (12). Inspect all parts for bends, breaks, or cracks, and ball (15) for roundness. Replace damaged parts. Install spring (16), ball (15), and clevis pin (17) to clevis (13) and PTO arm (14) and adjust shift rod (12) to measure 5.63 in. (14.3 cm) from centers of clevis (13) and clevis (11). 13-34