TM 9-2320-361-20 13-8. REAR WINCH CONTROL LEVER LINKAGE MAINTENANCE (M764) This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM] M764 TM 9-2320-361-10 MATERIALS/PARTS Four cotter pins Locknut TM 9-2320-361-20P EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). 1. Remove cotter pin (19) and clevis pin (16) from control lever (17) and winch control rod (14). Discard cotter pin (19). 2. Remove locknut (20), screw (15), and winch control lever (17) from bracket (18). Discard locknut (20). 3. Remove cotter pin (4), clevis pin (7), and rod (14) from pivot bar (5). Discard cotter pin (4). 4. Remove two cotter pins (22) and (3), clevis pins (21) and (6), and winch control clevis (2) from lever (1) and pivot bar (5). Discard cotter pins (22) and (3). 5. Remove jamnut (9), nut (8), washer (10), screw (13), washer (12), and pivot bar (5) from bracket (11). NOTE After nut has been tightened in step 1, ensure pivot bar moves freely. 1. Install pivot bar (5) on bracket (11) with washer (12), screw (13), washer (10), nut (8), and jamnut (9). 2. Connect clevis (2) to lever (1) and pivot bar (5) with two clevis pins (6) and (21) and new cotter pins (3) and (22). 3. Adjust rod (14) to measure 58.13 in. (148 cm) from center of clevis (23) pin hole and center of clevis (24) pin hole. 4. Install rod (14) to pivot bar (5) with clevis pin (7) and new cotter pin (4). NOTE After locknut has been tightened in step 5, ensure control lever moves freely. 5. Install winch control lever (17) on bracket (18) with screw (15) and new locknut (20). 6. Connect winch control rod (14) to control lever (17) with clevis pin (16) and new cotter pin (19). 13-14