TM 9-2320-361-20 13-6. FRONT WINCH PROPELLER SHAFT REPLACEMENT This task covers: a. Removal c. Installation b. Inspection INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All LO 9-2320-209-12-1 MATERIALS/PARTS TM 9-2320-361-10 TM 9-2320-361-20P Two cotter pins Four locknuts EQUIPMENT CONDITION GAA grease (Appendix C, Item 13) Parking brake set (TM 9-2320-361-10). NOTE Place front winch control lever in LOW position to remove screws, then in NEUTRAL position to gain access to remaining screws. 1. Remove four screws (3), locknuts (l), and rear flange (11) from transmission power takeoff flange (2). Discard locknuts (l). 2. Remove two cotter pins (6), pin (5), propeller shaft (4), and yoke (8) from front winch shaft (7). 3. Slide rear yoke (10) off propeller shaft (4). Inspect two universal joints (9) for looseness or roughness. If damaged, replace (para. 7-4). 1. Place a light coat of GAA grease on propeller shaft (4) splines and install rear yoke (10) and rear flange (11) on propeller shaft (4). 2. Install front yoke (8) and propeller shaft (4) on front winch shaft (7) and aline pin (5) hole with front winch shaft (7) hole. Install pin (5) through front yoke (8) and winch shaft (7) and secure with two new cotter pins (6). 3. Install rear yoke (10) and rear flange (11) to transmission PTO flange (2) with four screws (3) and new locknuts (l). FOLLOW-ON TASK: Lubricate front winch propeller shaft (LO 9-2320-209-12-1). 13-12