12-105. TM 9-2320-361-20 This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION M756A2 • Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS • Floodlight and brackets removed (para. 4-43). •Clearance marker lights and brackets removed Twenty locknuts (para. 4-45). PERSONNEL REQUIRED • Cab protector wiring harness removed (para. 4-52). Ž Rear winch drum clutch lever and guide plate Two removed (para. 13-9). REFERENCES (TM) • Step plate removed (para. 12-104). TM 9-2320-361-10 GENERAL SAFETY INSTRUCTIONS TM 9-2320-361-20P All personnel must stand clear during lifting operations. WARNING All personnel must stand clear during lifting operations. A swinging or shifting load may result in injury to personnel. 1. Remove four locknuts (11), screws (3), and tool bracket (12) from cab protector (13). Discard lock- nuts (11). 2. Secure chain sling (1) to cab protector (13) and lifting device (2). Raise lifting device (2) enough to remove slack from chain sling (1). 3. Remove eight locknuts (8), washers (7), and screws (4) from cab protector (13) and four brackets (6). Discard locknuts (8). 4. Remove eight locknuts (9) and screws (10) from cab protector (13) and two winch supports (5). Discard locknuts (9). NOTE Assistant will help with step 5. 5. Remove cab protector (13) with lifting device (2) from two winch supports (5) and four brackets (6). 6. Remove chain sling (1) from cab protector (13). 1. 2. 3. 4. 5. NOTE Assistant will help with step 1. Secure chain sling (1) to cab protector (13), and install cab protector (13) on two winch supports (5) and four brackets (6) with lifting device (2). Install eight screws (10) and new locknuts (9) on two winch supports (5) and cab protector (13). Install eight screws (4), washers (7), and new locknuts (8) on four brackets (6) and cab protector (13). Remove chain sling (1) from cab protector (13). Install tool bracket (12) on cab protector (13) with four screws (3) and new locknuts (11). 12-172