12-102. TM 9-2320-361-20 This task covers: a. Front Splash Guard Removal c. Rear Splash Guard Installation b. Rear Splash Guard Removal d. Front Splash Guard Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) M756A2 TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Eleven locknuts EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). NOTE • Left and right front splash guards are removed the same, except for fuel tank brace on left side. This procedure is for the right front splash guard. • Perform steps 1 and 2 if brace is damaged and requires replace- ment. 1. Remove fuel tank (para. 3-24). 2. Remove locknut (2), screw (5), and brace (4) from fuel tank support (3). Discard locknut (2). 3. Remove locknut (6), screw (8), and brace (4) from splash guard (7). Discard locknut (6). 4. Remove two locknuts (10), screws (9), and splash guard (7) from toolbox (1). Discard locknuts (10). NOTE Left and right rear splash guards are removed the same. This procedure is for the right rear splash guard. 1. Remove two locknuts (18) and (16), screws (19) and (14), and brace (17) from frame (15) and splash guard (20). Discard locknuts (18) and (16). 2. Remove two locknuts (13), screws (12), and splash guard (20) from mounting bracket (22). Discard locknuts (13). Discard locknuts (13). 3. Remove three locknuts (21), screws (23), and mounting bracket (22) from frame (11). Discard locknuts (21). NOTE Left and right splash guards are installed the same. This procedure is for the right rear splash guard. 1. Install mounting bracket (22) on frame (11) with three screws (23) and new locknuts (21). 2. Install splash guard (20) on mounting bracket (22) with two screws (12) and new locknuts (13). 3. Install brace (17) on splash guard (20) and frame (15) with two screws (14) and (19) and new locknuts (16) and (18). 12-168